本文转载自木棉花《Winter Breeze》

PATTERN:

See diagrams A.1 to A.10. Diagrams show all rows in pattern seen from RS. Repeat diagrams after mid st.

KNITTING TIP 1:

A.2, A.5 and A.8 in diagram always show the sts the way they are worked directly after edge st at beg of row or directly after mid st (seen from RS). A.3, A.6 and A.9 show 1 repetition that is repeated as many times as possible after A.2, A.5 or A.8 before enough sts remain for A.4, A.7 or A.10.

A.4, A.7 and A.10 always show the sts the way they are worked directly before mid st or directly before edge st at end of row (seen from RS).

KNITTING TIP 2:

A.3, A.6 and A.9 show 1 repetition in breadth – make sure to make the same no of YOs as sts dec in one repetition so that no of sts in every repetition is constant.

The same applies to the other diagrams but here inc 1 st in one side so that the repetition inc with 1 st every other row.

BOBBLE:

The bobble is worked over 2 rows.

ROW 1 (= RS): Work 7 sts in 1 st as follows: * K 1, 1 YO *, repeat from *-* a total of 3 times and finish with K 1 = 7 sts. It is important to work the sts loosely (approx. 1 cm long).

ROW 2 (= WS): P these 7 sts tog. It will be difficult to work the sts from 1st row tog if they are too short and too tight.

---------------------------------------------------------

SHAWL:

The piece is worked back and forth on circular needle because of no of sts. The piece is worked top down.

Cast on 7 sts on circular needle size 3.5 mm with Lace and work as follows:

ROW 1 (= RS): K 2, work 1st row in A.1, K 1 (= mid st), 1st row in A.1 and K 2.

ROW 2 (= WS): K 2, P 7 (= 3 sts from 2nd row in A.1, mid st and 3 sts from 2nd row in A.1) and K 2.

ROW 3 (= RS): K 2, work 3rd row in A.1, K 1 (= mid st), 3rd row in A.1 and K 2.

ROW 4 (= WS): K 2, P 11 (= 5 sts from 4th row in A.1, mid st and 5 sts from 4th row in A.1) and K 2.

Continue like this with lace pattern according to diagram. I.e. work every row from RS as follows: K 2 edge sts, lace pattern according to diagram A.1 (with inc), K 1 (= mid st), lace pattern according to diagram A.1 (with inc) and K 2 edge sts.

Work every row from WS as follows: K 2 edge sts, P until 2 sts remain and finish with K 2 edge sts.

When A.1 has been worked 1 time vertically, a total of 60 sts have been inc (= 67 sts on row) and pattern fits one extra repetition – this will happen automatically when working according to diagram.

When A.1 has been worked 1 time vertically, continue lace pattern as follows - Read KNITTING TIP 1 and 2:

1ST ROW (= RS), K 2, work A.2, A.3 and then A.4, K 1 (= mid st), work A.2, A.3 and then A.4 and finish with K 2.

ROW 2 (= WS): K 2, P until 2 sts remain and finish with K 2.

Continue the pattern like this according to diagram A.2 – A.4 until piece measures approx. 50 cm in the middle of mid st – adjust after one whole repetition vertically (i.e. after one whole leaf). Now work lace pattern according to diagram A.5, A.6 and A.7 the same way until 1 repetition has been worked vertically, then work lace pattern according to diagram A.8, A.9 and A.10 the same way until 1 repetition has been worked vertically. Then loosely cast off as follows – NOTE: It is very important to cast off very LOOSELY otherwise the edge cannot be shaped into tips: * Cast off 2 sts (pull sts somewhat when working them and cast off so that they are loose), make 1 loose YO on right needle, cast off YO *, repeat from *-* the entire row.

BLOCKING:

Place the shawl in lukewarm water until it is soaking wet. Carefully squeeze the water out of the shawl - do not twist the shawl - then roll the shawl in a towel and squeeze to remove more water - the shawl will now only be moist. Place the shawl on a carpet or mattress - carefully stretch it out to size and fasten it with pins. NOTE: Along the shawl's 2 diagonal sides insert 1 pin in every repetition in sts between 2 YOs and 1 pin in mid st (= at the bottom tip on shawl), lightly pull at every pin so that the edge is shaped with small tips. Leave to dry. Repeat the process when the shawl has been washed.

See diagrams A.1 to A.10. Diagrams show all rows in pattern seen from RS. Repeat diagrams after mid st.

KNITTING TIP 1:

A.2, A.5 and A.8 in diagram always show the sts the way they are worked directly after edge st at beg of row or directly after mid st (seen from RS). A.3, A.6 and A.9 show 1 repetition that is repeated as many times as possible after A.2, A.5 or A.8 before enough sts remain for A.4, A.7 or A.10.

A.4, A.7 and A.10 always show the sts the way they are worked directly before mid st or directly before edge st at end of row (seen from RS).

KNITTING TIP 2:

A.3, A.6 and A.9 show 1 repetition in breadth – make sure to make the same no of YOs as sts dec in on

The same applies to the other diagrams but here inc 1 st in on

BOBBLE:

The bobble is worked over 2 rows.

ROW 1 (= RS): Work 7 sts in 1 st as follows: * K 1, 1 YO *, repeat from *-* a total of 3 times and finish with K 1 = 7 sts. It is imp

ROW 2 (= WS): P these 7 sts tog. It will be difficult to work the sts from 1st row tog if they are too short and too tight.

---------------------------------------------------------

SHAWL:

The piece is worked back and forth on circular needle because of no of sts. The piece is worked top down.

Cast on 7 sts on circular needle size 3.5 mm with Lace and work as follows:

ROW 1 (= RS): K 2, work 1st row in A.1, K 1 (= mid st), 1st row in A.1 and K 2.

ROW 2 (= WS): K 2, P 7 (= 3 sts from 2nd row in A.1, mid st and 3 sts from 2nd row in A.1) and K 2.

ROW 3 (= RS): K 2, work 3rd row in A.1, K 1 (= mid st), 3rd row in A.1 and K 2.

ROW 4 (= WS): K 2, P 11 (= 5 sts from 4th row in A.1, mid st and 5 sts from 4th row in A.1) and K 2.

Continue like this with lace pattern according to diagram. I.e. work every row from RS as follows: K 2 edge sts, lace pattern according to diagram A.1 (with inc), K 1 (= mid st), lace pattern according to diagram A.1 (with inc) and K 2 edge sts.

Work every row from WS as follows: K 2 edge sts, P until 2 sts remain and finish with K 2 edge sts.

When A.1 has been worked 1 time vertically, a total of 60 sts have been inc (= 67 sts on row) and pattern fits on

When A.1 has been worked 1 time vertically, continue lace pattern as follows - Read KNITTING TIP 1 and 2:

1ST ROW (= RS), K 2, work A.2, A.3 and then A.4, K 1 (= mid st), work A.2, A.3 and then A.4 and finish with K 2.

ROW 2 (= WS): K 2, P until 2 sts remain and finish with K 2.

Continue the pattern like this according to diagram A.2 – A.4 until piece measures approx. 50 cm in the middle of mid st – adjust after on

BLOCKING:

Place the shawl in lukewarm water until it is soaking wet. Carefully squeeze the water out of the shawl - do not twist the shawl - then roll the shawl in a towel and squeeze to remove more water - the shawl will now on

= K from RS, P from WS | |

= slip 1 st as if to K, K 1, psso | |

= 1 YO between 2 sts | |

= K 2 tog | |

= slip 1 st as if to K, K 2 tog, psso | |

= bobble - see explanation above |

评论这张

<#--最新日志，群博日志-->
<#--推荐日志-->
<#--引用记录-->
<#--博主推荐-->
<#--随机阅读-->
<#--首页推荐-->
<#--历史上的今天-->
<#--被推荐日志-->
<#--上一篇，下一篇-->
<#-- 热度 -->
<#-- 网易新闻广告 -->
<#--右边模块结构-->
<#--评论模块结构-->
<#--引用模块结构-->
<#--博主发起的投票-->

## 评论